Filling The Water Tank; Setting The Temperature; Steam Ironing - TREVIDEA G3 Ferrari VISIR G40012 Manual Del Usuario

FILLING THE TANK
The filling operation must be performed only when the plate has been cooled down and after having
unplugged the unit from the electrical outlet. We recommend the use of demineralized water to prevent
excessive fouling (not covered by warranty).
Place the steam control knob (3) on "0".
1)
2) Open the water tank lid (2).
3) Raise the tip of the iron to avoid any leak of water during the operation.
4) Enter the water up to the maximum level (300ml) indicated with "MAX" on the tank.
5) Close the lid (2).
TEMPERATURE SETTING
The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
• It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since ironing plate heats faster than it cools down.
• When you do not know the composition, it is recommended to iron a non-visible part of the it, starting from
the lowest temperature to find the most suitable temperature.
• Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate and
the fabric.

Setting the temperature

1) Place the iron vertically.
2) Plug the device to the electrical outlet.
3) Select the temperature regulator (9) according to the symbols shown on the previous page. The chosen
symbol has to be aligned with the mark placed on the tank. The iron plate temperature control light shows
that the iron plate (6) is warming up. Wait until light turns off to start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is constant. If
you lower the thermostat, do not start ironing until iron temperature control light turns off.

STEAM IRONING

Before using the steam check that the water contained in the tank is enough. Adjust steam power using the
control knob (3). Place the steam control knob between minimum and maximum depending on the amount of
steam required and temperature.
Caution: the iron provides continuous steam only if it is held in a horizontal position and if the plate is hot. It
is possible to stop the continuous jet of steam by placing the iron vertically or placing the steam control (3) to
"0".To avoid the dripping of water, it is recommended to only use steam at high temperatures.
LABEL FABRIC
Synthetic
(Acrylic, nylon...)
silk – wool
cotton – linen
TEMPERATURE
·
Low temperature
··
Medium temperature
···
High temperature
Do not iron
13