Hilti NURON NCT 45 S-22 Manual De Instrucciones Original página 10

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless, electro-hydraulic cutting tool.
It is designed for cutting through cables made of steel (e.g. ACSR).
Before work commences, all live cables and other equipment carrying electric voltage within the area in
which the user is working must be switched off. If this is not possible, the corresponding safety precautions
for working in proximity to live cables or equipment must be implemented and observed.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
•
operating instructions.
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• Do not use the product in heavy rain or under water.
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable
at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is
switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
6 English
1
Pivoting bar
@
Securing screw, cutting edge in pivoting bar
;
Securing screw, cutting edge in cutting head
=
Cutting head
%
Piston return switch
&
Servicing and fault indicator
(
Installation opening for accessories
)
Work-area light
+
Control switch
§
Locking lever
/
Cutting edge in cutting head
:
Cutting edge in pivoting bar
∙
Battery status indicator
$
Battery release button
£
Battery
|
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
2321710
*2321710*