Publicidad
Step 11
Carefully stand your unit upright with help from a friend.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the outer end of the slot as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the end of the slot. Then
tighten the mounting screw.
Fasten the OUTER LEFT DOOR (L) to the LEFT END (B) and OUTER RIGHT
å
DOOR (K) to the RIGHT END (A). Use the screws in the HINGES. You should
start each SCREW a few turns before completely tightening any of them.
Fasten a PULL (12K) to the OUTER DOORS (K and L). Use four GOLD 1"
å
MACHINE SCREWS (50S).
Peel a felt disc from the FELT DISC CARD (1M) and stick it on the corner
å
of the DOOR where comes in contact with the UPPER SHELF (D).
Repeat this step for the INNER DOORS (K and L).
å
See the next step for DOOR adjustments.
å
12K
www.sauder.com/services
OUTER LEFT
DOOR (L)
B
1M
GOLD 1" MACHINE SCREW
(8 used in this step)
INNER RIGHT
DOOR (K)
50S
419717
Hinge
INNER LEFT
DOOR (L)
OUTER RIGHT
DOOR (K)
D
12K
Slot
Mounting
screw
A
Page 15
Publicidad
