AKO 16526A Manual Del Usuario página 20

Description
The AKO-16526A advanced controller for cold room stores has a SELFDRIVE operating mode that automatically
controls (without parametrisation) the fans and adaptively minimises defrosts to optimise the performance of the
cold room store: maximising time in set point and minimising costs linked to energy consumption and wear of
components.
It has an output to regulate the electronic expansion valve. It can be configured so it can control superheating, as
well as adjust the cold in the store.
1: Display 2: Keypad
Constant: Stand-By Mode activated. Regulation
is paused.
Flashing: Controlled stop process for the regu-
lation in progress.
Constant: Cold room door open.
Flashing: The door has been open for a longer
time than defined in parameter A12.
There is an active alarm (No HACCP or temper-
ature).
Constant: HACCP alarm active.
Flashing: HACCP alarm recorded and
unconfirmed To acknowledge an HACCP alarm,
press the key.
The temperature alarm is active.
Constant: Evaporator fans active.
Flashing: The evaporator fans
should be active but something is
preventing them from activating.
Constant: The COOL relay is active.
Flashing: The COOL relay should be active but a
delay or protection is preventing this.
Pulsing: Expansion valve regulated.
1 2
20
3516526A11 Ed. 01
Constant: The SELFDRIVE mode is active.
Flashing: An error has been detected in SELF-
DRIVE mode. To view it, press the  key.
Constant: Compressor active.
Flashing: The compressor should be active but
a delay or protection is preventing this.
Defrosting active.
Continuous cycle mode active.
Cold room light active.
Alarm in progress muted.
Temperature displayed in ° Fahrenheit / ° cen-
tigrade.
Programming mode active.
Lower display showing the real time superheat-
ing value.
Lower display showing percentage of EEV
opening or percentage of evaporator fan power
(depending on configuration)
Lower display showing low pressure in psi / bar.