Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS OF THE HEATER
Parts of the heater
1. Thermostat Control
2. Pilot Light
3. Power Control
4. Safety Grille
OPERATING INSTRUCTIONS
1. Set the heater on a dry, level surface.
2. Make sure the Power Control is in
120 V AC outlet.
3. Set the Thermostat Control all the way to
4. Set the Power Control to
comfortable, select
from becoming too warm.
5. Your heater is equipped with an oscillation feature. If you want to obtain a wider area of heat circulation, turn the Power Control
to
or
.
6. This heater is equipped with a thermostat function to control the temperature output. To increase the heat output, turn the
Thermostat Control clockwise to
PILOT LIGHT
This fan heater is equipped with a Pilot Light, which glows whenever the heater is plugged in and turned on. It will continue to glow
even if the thermostat has cycled the heating elements off. This feature is to prevent you from being unaware that the heater is in
operation.
TIP-OVER SWITCH
This heater is equipped with a safety tip-over switch, which is located on the bottom of the heater. This feature cuts the main power
to the heater if it gets knocked over. If the heater does tip over, simply stand it upright in order to resume operation.
THERMAL CUT-OFF PROTECTION SYSTEM
This heater includes an Overheat Protection System that shuts the unit off when a potential overheat temperature is reached. If this
occurs, the heater can only resume its normal operation after resetting it. To reset the heater:
1. Turn the Power Control to OFF position.
2. Unplug the heater and wait 10 minutes for the unit to cool down.
3. After the 10 minutes, plug the unit in again and operate normally.
CLEANING AND MAINTANENCE
1. Turn the Power Control to
2. Interior dust can often be removed by using a vacuum cleaner with a crevice tool attachment.
3. To clean the enclosure, use a clean, soft and lightly damp cloth to gently wipe off the dirt from the surface of the unit. Be sure
not to wet the Heating Element and the switches. Allow the unit to dry completely before use.
4. Do not use cleaning liquid or other chemicals to spray on the unit
STORAGE
1. Perform the cleaning procedures described above.
2. Wipe all parts dry.
3. Pack the heater in a plastic bag and store it in a cool, dry place. We recommend that you store the heater in its original carton.
TROUBLE SHOOTING
If your heater fails to operate:
Make sure the electrical outlet or circuit breaker is working.
Check for obstructions. If you find an obstruction, turn the heater OFF, and UNPLUG THE UNIT. Carefully remove the
obstruction and follow the reset instructions.
The thermostat might be set too low. Turn the thermostat knob clockwise until the heater restarts.
Symbols
Power Off
Low Heat Setting
High Heat Setting
Low Heat Setting with Oscillation
High Heat Setting with Oscillation
(off) position. Plug cord into any standard
(maximum).
for fast warm up of a room. Once the room is
to reduce electrical consumption and to prevent the room
. To reduce the heat output, turn the Thermostat Control counterclockwise to
(off) position and unplug the heater before moving or cleaning.
.
Publicidad
