Raider RDI-AG47 Manual Del Usuario página 14

14 www.raider.bg
General guidelines for safe operation.
Read all instructions carefully. Failure of the nature following instructions can cause
electric shock, fire and / or severe injuries. Keep these instructions in a safe place.
1. Safety in the workplace.
1.1. Keep your workplace clean and well lit. Disarray and poor lighting may contribute to
the occurrence of an accident.
1.2. Do not operate in an environment of grinding increased the risk of explosion, close to
flammable liquids, gases or powders.
During operation of the separate grinding sparks that can ignite powders or fumes.
1.3. Keep children and bystanders at a safe distance while working with angle grinders.
If your attention is diverted, you may lose control over grinding.
2. Safety when working with electricity.
2.1. Plug the grinding must be suitable for contact. In no case is allowed to modify the
structure of the plug. When working with electrical zero, do not use plug adapters.
Using original plugs and sockets reduces the risk of electric shock.
2.2. Avoid touching your body to earthed bodies, for example pipes, heaters, stoves and
refrigerators. When your body is grounded, risk of electric shock is greater.
Keep grinding from rain and moisture.
Infiltration of water into the grinding increases the risk of electric shock.
2.3. Do not use a power cord for the purposes for which it is not provided, for example to
carry grinders for cable or removing the plug from the outlet. Protect cords from heat, oil and
contact with sharp edges or points of mobile machines.
Damaged or twisted cables increase the risk of electric shock.
2.4. When you work with the angle grinder out, switch the machine only in installations
equipped with electric switch "Fi" RCD (Residual Current Device). RCD must be no more than
30 mA. Use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
2.5. If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
Using the extension, designed for outdoor use reduces the risk of electric shock.
3. Safer way of working.
3.1. Be concentrated, watch their actions carefully and act cautiously and prudently. Do not
use the angle grinder when you are tired or under the influence of drugs, alcohol or narcotic
drugs.
A moment of distraction at work grinding may have the effect of extremely serious injuries.
3.2. Work with protective work clothing and always with safety glasses.
Wearing Suitable for grinding and the activities of personal protective equipment, such as
respiratory masks, healthy, tightly closed shoes grapple with a stable, protective helmet and
silencers (hearing protectors), reduces the risk of accident.
3.3. Avoid the danger of incorporating the grinding inadvertently. Before you turn the plug
into the power supply network, make sure the trigger switch is in position "off". If you wear
when grinding, keep your finger on the trigger switch, or if you submit a voltage of grinding
when turned on, there is the risk of accident.
3.4. Before you turn implies that we are sure you remove all of its utilities and wrenches.
Utilities, forgotten rotating unit can cause injuries.
3.5. Avoid unnatural positions of the body. Work in a stable position of the body at any
time and keep the balance. So you can control the grinding better and safer if unexpected
situations arise.
3.6. Work with appropriate clothing. Do not operate with loose clothing or ornaments. Keep
your hair, clothes and gloves at a safe distance from rotating the grinding units. Robes, attire,
long hair can be caught and carried away by rotating units.
3.7. If it is possible to use external aspiration system, make sure it is switched on and
functioning properly. Use of the aspiration system reduces the risks due to the discharge dust
at work.