Publicidad
Step 7
Carefully turn your unit over onto its front edges.
å
Fasten two TIE PLATES (3G) to the END MOLDINGS (H)
å
and the BASE (G). Use four BLACK 9/16" LARGE HEAD
SCREWS (1S).
Fasten two TIE PLATES (3G) to the END MOLDINGS (H)
å
and the TOP MOLDING (I). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
NOTE: There are no pre-drilled holes in the END
å
MOLDINGS. The SCREWS will tighten into the grooves.
G
H
3G
www.sauder.com/services
3G
G
H
BLACK 9/16" LARGE HEAD SCREW
419200
(4 used)
3G
I
H
1S
(8 used in this step)
Page 11
Publicidad
