Publicidad
ASSEMBLY INSTRUCTIONS
We recommend you assemble your fireplace on a carpeted surface or towel to prevent damage to your floor or the fireplace.
Step 1
Take one of the glass pieces and he fireplace
body and place on a towel or carpeted floor
to avoid scratches to the unit.
Step 2
Attach the glass to the fireplace body by following the diagram to
the right. Place the screw into the clear washer and then insert it
into the hole in the glass from the outside. Then line up the glass
with the screws to the holes in the side of the fireplace body.
Step 3
To attach the glass, while the screws are lined up and in the holes
of the fireplace body, take the metal washer and nut and meet the
screw from the underside of the fireplace body. To tighten, turn the
screw clockwise while holding the nut under the fireplace body in
place. Do not over tighten. Hand tight is OK and glass should not
wobble or be loose. REPEAT STEPS FOR 2nd PIECE OF GLASS.
Step 4
Drop in the burner sleeve and burner into the fireplace body. Note
there may be a small bump in the sleeve that needs to line up with
the body in order to get it to drop in correctly.
Publicidad
