Chef's Choice 680 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Avoid spilling water on the base unit. In the event the base unit becomes wet, proceed
as follows:
– disconnect the power cord from the power outlet.
– invert base unit and shake out all water.
– dry the base unit with a dry absorbent cloth.
– place the Kettle on the base and re-insert the power cord into the power outlet.
CAUTION: The Kettle always gets hot during operation. DO NOT touch the glass body
or lid. Lift the Kettle only by the handle and open the lid only by using the lid release
button or knob. Exercise care to avoid contact with steam or the water when opening
or closing the lid while the Kettle is still hot or contains hot water.
CARE AND MAINTENANCE OF YOUR
CHEF'SCHOICE
The Chef'sChoice® Kettle is designed specifically for heating water. Do not attempt to
heat anything other than water in the Kettle. With liquids and mixtures of low water
content, the automatic steam activated shut-off switch may not function properly and
the Kettle may be damaged.
Before cleaning, make sure power switch is turned "OFF", then remove the Kettle from
its base unit. Unplug the base unit.
Always wait until the Kettle has fully cooled to room temperature before cleaning.
To avoid scratching, clean the outside of the Kettle with a soft cloth only. Never use
abrasive cleanser.
Never use abrasive cleansers or abrasive pads on either the inside or outside glass
surface of this product.
The interior of the Kettle can be cleaned by decalcification at regular intervals (see
next page).
Rinse out the Kettle at regular intervals and after extended non-use. Do not immerse.
Do not attempt to clean any part of the Kettle or base in the dishwasher.
®
ELECTRIC KETTLE
English — 6

Publicidad

Tabla de contenido
loading

Tabla de contenido