Learn Mode - Hama Big Zapper Instrucciones De Uso

To deactivate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL-" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL-" (the indicator is flashing twice if
the setting is deactivated).
6.3 Macro Power
Macro Power enables you to turn two TV/STB
devices on/off simultaneously.
To activate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator flashes once if
the setting is activated).
To deactivate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator is flashing
twice if the setting is deactivated).

7. LEARN MODE

This remote control is equipped with a learning
function. Thus, you could learn functions of your
original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to
be in good condition. Replace them if necessary.
• Place the remote controls with the infrared
diodes so that they point towards each other.
• Where necessary adjust the height of both
remotes so that infrared diodes are properly
aligned.
• The distance between the remote controls should
be about 3 cm.
ROC1117GRU
BIG ZAPPER
ORIGINAL
ca. 3 cm
Note
• Do not move the remote controls during
the learning procedure.
• Ensure that the room is not lit by
fluorescents tubes or low energy
consumption lamps since such light
sources could interfere with the copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is
selected for more than 30 seconds, the
learning mode will exit automatically or
if no other remote signal is received.
• Each function key will hold only one
command. A new command to be learned
will automatically replace the previous one.
• It is not possible to learn any new
functions to the TV, STB and Setup key.
7.2 ENTER LEARN MODE
1. Press and hold the [MUTE] and [VOL+] keys
for approx. 3 seconds until the LED will be lit.
2. Enter the code [9] [8] [0], the LED will flash
2 times and then remain on.
3. The Universal Remote Control is now ready to
learn new commands.
7.3 LEARNING OF KEYS
1. Press and release the desired key on the
original remote control which you want the
command to be learned. The LED at your
Universal Remote Control will flash to confirm
that the information has been received.
2. Then press and release the target key on the
Universal Remote Control you want learned.
3. If the LED flashes 3 times and then remain on,
the command has been learned successfully.
5