User Servicing Instructions; Replace The Fuse - Holiday living W14F0708 Manual Del Usuario

USER SERVICING INSTRUCTIONS

Replace the fuse

This product comes with overload protection (fuse). A blown fuse indicates an overload or short circuit. If a fuse blows,
unplug tree from wall outlet. Replace the fuse as per the fuse replacement instructions below (follow product marking for
proper fuse rating). If the replacement fuse blows, a short circuit may be present and the product should be reviewed to
determine the cause.
A) Light set fuse replacement (replaceable 3 amp, 125 volt fuses)
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open the fuse access cover on top of attachment plug toward blades.
3. Remove fuse carefully.
4. Risk of fire. Replace with only a 3 amp, 125 volt fuse (provided with product).
5. Close fuse cover. Slide close the fuse access cover on top of attachment plug.
CAUTION:
125 volt fuse. Do not replace attachment plug. Discard product if the attachment plug is damaged.
B) Extension cord fuse replacement (replaceable 5 amp, 125 volt fuse is located in the plug):
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open the fuse access cover on top of attachment plug toward blades.
3. Remove fuse carefully.
4. Risk of fire. Replace with only a 5 amp, 125 volt fuse (provided with product).
5. Close fuse cover. Slide close the fuse access cover on top of attachment plug.
CAUTION:
amps, 125 volt fuse. Do not replace attachment plug. Discard product if the attachment
plug is damaged.
Replace the lamp.
Grasp plug and remove from the receptacle or other outlet device.

Do not unplug by pulling on cord.
Pull bulb and plastic base straight out of lampholder.

Replace with only a 2.5 volt, 0.425 watt (super bright) type bulb (provided with product).

If the new lamp base does not fit in lampholder, follow these steps:
Remove the base of burned out bulb by straightening lamp leads and gently pull bulb out.

Thread leads of new bulb through holes in old base with one lead in each hole.

After bulb is fully inserted into base, bend each lead up so that the leads will touch the

contacts inside the lampholder.
To reduce risk of fire – replace fuse in extension cord with only 3 amp,
To reduce risk of fire – replace fuse in extension cord with only 5
7
Lowes.com