BAUKER BG750 Manual De Instrucciones página 22

Assure that the maintenance and repair of your power tool by a qualified repair person
using only identical replacement parts. This will ensure that the safety of the power tool
is maintained.
Special safety regulations for
Instrucciones de Seguridad Específicas
WARNING!: read and understand all the safety and operation instructions to avoid
hazardous situations.
a. Sparking occurs when grinding metal and it can cause injuries in your face or body.
Always wear safety glasses and clothes. Do not use unit or product around any
flammable material or fuel. Check that all the safety tool protectors and wheel guards
are properly mounted.
b. Before mounting a new wheel, be sure that it is marked with an RPM that is the same
as, or higher than, the no load speed of the grinder as marked on the nameplate.
c. Cool pieces into water to avoid overheating. Do not water the bench grinder.
d. Use the tool rest to hold the pieces (4). If it is not used the torsion of the wheel could
remove pieces from your hand and cause hazardous situations.
e. Do not use aluminum oxide wheels when grinding non-ferrous steel as aluminum
and brass. Use silicon carbide wheels.
f. When you grinding steel, always hold the steel by the lowest side of the polisher
wheel. Always keep your fingers away from the grinder wheel and the work piece tool
rest
Note: tool performance varies depending on voltage variations of the local line. The use
of extensions could affect the tool performance.
WARNING: The warnings, precautions and instructions declared in this manual
may not cover all possible conditions and situations that can occur. It must be
understood by the operator that common sense and self-precaution are factors
that cannot being incorporated in this product, but it must be provided by the
operator.
41
Service
angle grinder
para Esmeril de banco
1. Insert the plug into an electrical outlet.
2. Turn the speed control knob clockwise to turn on the motor and
adjust its speed
3. To turn off, turn the knob counter-clockwise until it clicks
4. Do not leave the bench grinder running unattended. Turn off the
tool when not in use
1. Always bring the workpiece into the wheel gently, without jarring.
2. Workpiece will heat quickly, thus, cold it frequently with water, when it be required
3. When grinding high speed steels such as drills and tool bits, avoid high temperature
buildup as this can affect the temper of the steel. Maintain it freezing.
4. For small workpieces such as drill bits or chisels, avoid apply pressure to the wheel at
a high angle that could cause the workpiece to become lodged between the tool rest and
the wheel.
Caution: Before operating, adjust the distance
between the holder and the grinding disc to ensure
that the distance is less than 2 mm.
Assembly
of the table saw
Turn Off and On
Grinder Use
42