D-Link DCS-4605EV Guía De Instalación Rápida página 10

Using the DCS-37-1 Mount (optional)
Place the DCS-37-1 mounting sticker in the desired
location, then use a 6 mm drill bit to drill the required holes
25 mm deep and insert the wall anchors into the holes.
If you plan to pass cables through the wall, you will also
need to drill a hole for the cable channel.
Note: The camera in the corresponding graphics may be
different from your product, but the basic process is the
same.
Use the provided screws to mount the DCS-37-1 to the
wall.
Guide the camera connectors through the back or bottom
cable channel on the DCS-37-1. Then screw the mounting
plate to the bracket using the set of mounting holes
marked B.
Remove the cover from the camera.
Use the provided screws to mount the camera to the
DCS-37-1, then adjust the angle and rotation of the
camera as desired using the tilt lock screw.
Attach the camera cover.
If you are passing the camera cables through the wall,
place the rubber stopper into the bottom cable channel on
the mount to seal it.
8
D-Link DCS-4605EV Quick Installation Guide