Installing The Handle - Makita XML06 Manual De Instrucciones

Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely dis-
charged. Always stop tool operation and charge the
battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room tempera-
ture at 10 °C - 40 °C (50 °F - 104 °F). Let a hot
battery cartridge cool down before charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
ASSEMBLY
WARNING:
Always be sure that the lock key
and battery cartridge are removed before carrying
out any work on the mower. Failure to remove the
WARNING:
Never start the mower unless it is
completely assembled. Operation of the machine

Installing the handle

NOTICE:
When installing handles, position the
cords so that they are not caught by anything
between the handles. If the cord is damaged, the
mower switch may not work.
1. Align the holes in the lower handle with the holes
1
2
1. Lower handle 2. Bolt
2.
tightened in step 1 using box wrench 13.
3. Align the hole in the lower handle with the hole in
the upper handle, then insert the bolt from inside, and
then tighten the nut from outside with box wrench 13.
Perform the same procedure on the other side.
-
1. Bolt 2. Lower handle 3. Nut 4. Hole 5. Upper
handle
CAUTION:
4. Attach the holders to the handle.
Align the protrusions on the holder with the holes on the
1. Cord 2. Holder
6 ENGLISH
5
4
3
Otherwise, the
1
1
2
2