Installing The Appliance; Cable Connections - SonicWALL APL26-0AE Manual Del Usuario

Safety information for installation and
operation


Installing the appliance



Cable connections


Lithium battery

Power supply information for APL26-0AE

Restricted environments

Radio or television interference
Installing the appliance
WARNING: For your safety, follow all instructions listed in this section.

Mount in a location away from direct sunlight and sources of heat. A maximum ambient temperature of
104º F (40º C) is recommended.
 Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,
transmitters, and broadband amplifiers

The included power cord(s) are approved for use only in specific countries or regions. Before using a
power cord, verify that it is rated and approved for use in your location.

Ensure that no water or excessive moisture can enter the unit.

Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of 1
inch (25.44mm) clearance is recommended.

Consideration must be given to the connection of the equipment to the supply circuit and that the effect
of overloading the circuits has minimal impact on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings must be used when addressing this concern.

This device is not intended for use in the direct field of view at visual display workplaces. To avoid
incommoding reflections at visual display workplaces, this device must not be placed in the direct field
of view.
Cable connections
WARNING: All Ethernet and RS232 (Console) cables are designed for intra-building
connection to other equipment. Do not connect these ports directly to
communication wiring or other wiring that exits the building where the appliance is
located.
5455 Great America Parkway
Santa Clara, California 95054 USA
Office +1 408 745 9600
Dell SonicWALL SonicPoint ACe
Safety and Regulatory Information
2