Triton SJA 420 Instrucciones De Uso página 5

e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
ASSEMBLY
Step 1
Unfold the Folding Arms (3) and rotate the Mounting
Knobs (4) so that they are squared up with the ends
of the arms.
Step 2
Feed them into the first set of mounting holes in the
side of the Superjaws and push them until the Stops
(5) locate against the Superjaws body.
The tool tray can be fitted to the left or right hand side
of the Superjaws.
Step 3
Rotate the mounting knobs 45˚ to lock them in position
Step 4
Locate the Tray (2) between the folding arms.
If fitting a second Tool Tray to your Superjaws, fit it to
the next series of mounting holes on the opposite side
to the first tray.
If using Superjaws with the jaw reversed (wide
clamping position) the Support Arm (1) can be
positioned higher so that it is level with the base of
the moving jaw. Loosen the Pivot Knobs (6) until the
Spacers (7) can be separated and the top spacer
rotated 90˚. Re-tighten the knobs
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
General Safety Instructions / Assembly
GB
5