Keep It Clean; Keep It Charged; Keep It Stored Over The Winter - Worx WR130E Manual Del Propietário

Attention: When fitting new blades, make sure you replace ALL the blades.
Always use new screws when fitting blades. This is important to ensure blade retention and balance the blade turning disc. Failure
to use new screws could cause serious injury
Important: After screwing the blade to the blade disc, make sure the blade is able to spin freely

5.2 Keep it clean

Your Landroid should be cleaned regularly. This helps keep it in good condition, especially removing dirt, debris and the build-up of
grass from daily mowing. Turn Landroid off before cleaning it. For extra safety, remove the battery.
WARNING! DO NOT use a hose, high pressure washer or otherwise pour running water on your Landroid.
High pressure water can go inside the sealings and damage electronic and mechanical parts.
5.2.1 .Cleaning the upper body
A. Clean with a spray bottle filled with water. Don't use solvents or polishers
B. Use a brush or a clean cloth to remove built-up dirt
5.2.2. Cleaning the Bottom
A. Flip Landroid upside down
B. Remove debris and grass clippings using a brush to remove
C. Be careful not to touch the blades with your hands. Wear gloves for protection
D. Clean the blade disc, the chassis and the front wheel(s) thoroughly with a soft brush or moist rag
E. Rotate the blade disc to ensure it rotates freely. Remove any obstructions. Remove any lodged debris so that they don't cause a
crack in the blade disk. Even the tiniest crack effects mowing performance
F. Check the blades spin freely around the fixing screws. Remove any obstructions
5.2.3. Cleaning the drive wheels
A. Remove mud from wheels with a brush in order to ensure good grip of the tread
5.2.4. Clearing the charging contacts
A. Clean the contact pins located on the charging base and the charging strips located on the Landroid using a cloth
B. Periodically remove any build-up of grass clippings or debris around the contact pins and the charging strips to ensure Landroid
successfully charges each time

5.3. Keep it charged

The heart of Landroid is its 20V Li-Ion Worx Powershare Battery.
A. For the proper storage of the battery, make sure it is fully charged and kept in a cool dry place.
B. The recommended Landroid operation temperature is between 0-55°C
C. The life-span of Landroid's battery depends on hours of usage and the length of use per day during the mowing season
5.3.1. Landroid can be charged manually without the boundary wire
A. Connect the charging base to a suitable power supply. The green light on the charging base will turn on
B. Manually dock Landroid into the charging base while Landroid is powered off
C. The green light on the charging base will flash and Landroid will begin to charge

5.4. Keep it stored over the winter

Although Landroid is designed and built to survive the most severe weather conditions, we recommend storing it in your shed or
garage during the winter. To prepare it for winter hibernation:
A. Clean it thoroughly
EN
15