Repair And Warranty - Megger AVO410 Guia Del Usuario

* <100 digit of reading rolling
Auto power off (APO):
Accessories
Battery (installed)
Test leads
User manual

Repair And Warranty

The instrument contains static sensitive devices, and care must be taken in
handling the printed circuit board. If an instrument's protection has been
impaired it should not be used, but sent for repair by suitably trained and
qualified personnel. The protection is likely to be impaired if for example; it
shows visible damage; fails to perform the intended measurements; has been
subjected to prolonged storage under unfavourable conditions, or has been
subjected to severe transport stresses.
Note: Any unauthorised prior repair or adjustment will automatically
invalidate the warranty.
Instrument Repair And Spare Parts
For service requirements for Megger instruments contact:
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
Tel: +44 (0) 1304 502 243
Fax: +44 (0) 1304 207 342
or an approved repair company.
Returning and Instrument for Repair
If it is necessary to return an instrument for repair, a Returns Authorisation
number must first be obtained by contacting one of the addresses shown. You
will be asked to provide key information, such as the instrument serial number
and fault reported when the number is issued. This will enable the Service
Department to prepare in advance for the receipt of your instrument, and to
provide the best possible service to you.
The Returns Authorisation number should be clearly marked on the outside of
the product packaging, and on any related correspondence. The instrument
should be sent, freight paid to the appropriate address. If appropriate a copies
14
If idle for more than 10 minutes
or Megger
Valley Forge Corporate Centre
2621 Van Buren Avenue
Norristown PA 19403 England. U.S.A.
Tel: +1 610 676 8579
Fax: +1 610 676 8625