Non-Contact Voltage Ncv; Functions Of The Keys - Chauvin Arnoux C.A 5233 Manual De Instrucciones

The measured current is displayed on screen.
3.1.8

Non-Contact Voltage NCV

1. Set the switch to
2. Move the C.A 5231 (NCV detection zone) close to the
potentially live conductor(s) (presence of phase);
3.
If a network voltage of 230V is present (Europe model),
the back-lighting lights red; otherwise, it remains off.

3.2 FUNCTIONS OF THE KEYS

The functions of the
can be accessed by successive short or long presses. Each
press is confirmed by an audible signal.
3.2.1 The
This key is used to select the type of measurement and the
display mode to deactivate the automatic switching off of the
device, at start-up, in combination with the switch. A long press
during start-up, while turning the
deactivates automatic switching off. The
displayed. As default, automatic switching off is activated and
the symbol is displayed.
Remark : the Dc mode is activated as default.
;
, ,
key
, , and
switch to any position,
symbol is not
English
keys
46 - 139