V-TAC VT-5158 Instrucciones De Instalación página 6

ENGLISH
A. DEVICE ADDING BY SCANNING THE CODE
• Tap on "device adding by scanning the code" (Ref Figure 9).
• Please refer to "TIP" before tapping on Next.
After you hear the sound from camera "Please configure camera by AP hotspot or by
scanning code" tap on Next (Figure 10)
• Enter your Wi-Fi Name and Password.
• Now if your mobile phone is already connected to network Wi-Fi, it will show your
network Wi-Fi name. If not, press "Switch the network" to open your phone's WLAN
and connect to your available network. Then go back to the app. Input Wi-Fi pass-
word (note: this password must be your network Wi-Fi password), and then click
"Next". A QR code will show on phone screen.
• Place the QR code towards the camera lens at a distance of around 4-8 inches.
After the camera reads the QR, it will sound with "two beeps" and Wi-Fi connecting.
Now on the App, tap on "Beep or flashing lights" (Figure 12). Then wait till the
camera confirms with "Internet connected" "welcome to use cloud camera". On app it
will also show "Addition is successful"- Select/type the device name (Figure 15) and
tap on "Start to experience".
FIGURE 11
FIGURE 10 FIGURE 12