Installation Instructions - HAMPTON BAY 997-388 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):

INSTALLATION INSTRUCTIONS:

1. Thread the Fixture Mounting Screws (#6) into the provided holes of the Mounting Bracket (#7) as shown. Thread the Hex
Nuts (#9) onto the Fixture Mounting Screws (#6), as shown. Do not tighten the Hex Nuts (#9) at this time.
2. Pull the power supply wires out from the Outlet Box (#4), and mount the Mounting Bracket (#7) to the Outlet Box (#4), using
the Bracket Mounting Screws (#8).
3. Attach the Black Supply Wire (#5) to the Black Fixture Wire (#12) and the White Supply Wire (#16) to the White Fixture Wire
(#13) using Wire Nuts (#14). Connect the Fixture Ground Wire (#11) and the Supply Ground Wire (#15) together using a
Wire Nut (#14). Wrap all wire connections with electrical tape for a more secure connection. Note: If you have electrical
questions, consult your local electrical code for approved grounding methods.
4. Place the Wall Plate (#10) over the Outlet Box (#4) and onto the Fixture Mounting Screws (#6), and adjust the Fixture
Mounting Screws (#6) until they protrude out from the Wall Plate (#10) 1/4". Remove the Wall Plate (#10) and secure the
position of the Fixture Mounting Screws (#6) by tightening the Hex Nuts (#9) against the Mounting Bracket (#7). Place the
Wall Plate (#10) back onto the Fixture Mounting Screws (#6), and secure it into place using the Lock Nuts (#3) provided.
5. After installing the fixture, caulk upper 2/3 of the Wall Plate (#10) to mounting surface. Leave bottom 1/3 un-caulked for
drainage of any water that might leak into the enclosure. The manufacturer recommends a non-drying exterior caulking
material. A good example is a clear silicone rubber sealant for exterior use.
6. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to activate the fixture.
Page 6
1 ea Mounting
Bracket (#7)
2 ea Hex
Nuts (#9)
3 ea Wire
Nuts (#14)
2 ea Bracket Mounting
Screws (#8)
2 ea Fixture Mounting
Screws (#6)
2 ea Lock
Nuts (#3)