ARDES AR5T75 Instrucciones Para El Uso página 14

Assembly.
Caution! The fan should always be switched off and does not connected
to the mains supply, if you mounting the fan.
- To fix the base to the body fan, set the fan gently on the head. Use a soft
surface to not damage the top of the product.
- Unscrew the plastic nut from the bottom by turning it anticlockwise
- Fix together the two half of the base on the bottom of the fan
- Screw up the plstic nut to fix the base on the bottom of the fan by turning
it clockwise.
- Fix the cable with the preassembled strain relief as showed in the
picture below (picture number 1).
Pay attention that all the parts are correct and firmly connected with each
other.
Caution! Connect to the mains supply only after the fan has been fully
assembled.
- The fan must not be used without a fixed base
- The device may be operated only in straight and upright position
- This device may not be used in a horizontal position
Before plug the product check if it is switched Off. Insert the plug of the
fan into a suitable socket outlet. Set the speed/oscillation using the knob
as below:
1 = low speed
2 = middle speed
3 = high speed
0 = off
1 = low speed with oscillation
2 = middle speed with oscillation
3 = high speed with oscillation
14
Instructions for use
Picture 1