For more information on the sensor see Remote Sensor
section.
To view minimum / maximum records:
Press MEMORY to toggle between current, maximum
(MAX) and minimum (MIN) records. To clear the records,
press and hold MEMORY for 2 seconds. A beep will
sound to confirm that the memory has been cleared.
To force a manual search for the sensor:
Press and hold CHANNEL and MEMORY. See Atomic
Clock section for how to check the signal status.
RADIO WR602
ABOUT THE NATIONAL WEATHER RADIO SYSTEM
The National Weather Service (NWS) is an agency
within the National Oceanic & Atmospheric
Administration (NOAA) that operates a nationwide
network of radio stations known as the NOAA Weather
Radio (NWR). The NWR radio system broadcasts
warning information for all types of hazards, both natural
and technological. Working in conjunction with the
Emergency Alert System (EAS), NWR is an all-in-one
hazards radio network and is considered to be the single
source of all comprehensive weather and emergency
information.
A nationwide network, the NWR consists of more than
800 stations in the United States, Puerto Rico, the US
Virgin Islands and US Pacific Territories. Broadcasts
are designed to meet local needs. Routine programming
is repeated every few minutes and consists of local
forecast, regional conditions and marine forecasts.
Additional information, including river stages and climatic
data, is also provided. During emergencies, these routine
broadcasts are interrupted to report specific warnings.
CONSUMER ELECTRONICS ASSOC. (CEA)
This product complies with the Consumer Electronics
Association (CEA) testing standards.
TURN THE RADIO ON / OFF
To turn the radio ON / OFF, press and hold
When the unit is first connected to the battery pack or
reset, on it will immediately enter the clock / language
setting mode (see Change Settings section). It is
advisable to set your preferred language English (E),
French (F) or Spanish (S) at this time, so you can read
the NOAA alert messages.
DISPLAY MODES
There are 2 display modes:
1.
Clock mode
2.
Radio status mode
To switch between the clock mode displays, press MENU.
14
.