Led Status; Hardware Installation; Software Installation - Steren COM-868 Manual De Instrucciones

LED STATUS

LED Indications
Green
Green
Green

HARDWARE INSTALLATION

1. Turn off your desktop PC and disconnect the power.
2. Open your PC case and locate an available PCI slot on the
motherboard. Remove the metal slot cover on the back of the
PC. Check with your computer manufacturer for instructions if
needed.
3. Slide the PCI Adapter into the PCI slot. Make sure that all
of its pins are touching the slot's contacts. Once the adapter is
fi rmly in place, secure its fastening tab to your PC's chassis with
a mounting screw. Then, close your PC case.
4. Reconnect your PC's power and turn on your desktop PC.

SOFTWARE INSTALLATION

The Adapter's Setup Wizard will guide you through the
Installation procedure for Windows 98Se, ME, 2000, XP. The
Setup Wizard will install the Wireless Client Utility (SWCU) and
drivers.
When you install the hardware before installing the software, the
system will prompt "Found New Hardware Wizard" window, click
Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 98Se, Me, 2000 and XP are very
similar. The following setup steps are for Windows 2000.
1. Insert the Resource CD into your CD-ROM drive, click Start
and choose Run. In the fi eld that appears, enter F:\XXX\Setup.
exe (if "F" is the letter of your CD-ROM drive; XXX is the setup
program path, which is labeled on the Resource CD), fi gure 1
should then appear.
Status
Intermittently
Lit
Flashing
ENGLISH-3
Working Status
The adapter is in an
electricity saving status or
the adapter is already
connected but is not
transmitting or receiving
data.
The adapter is on wake up
status.
The adapter is transmitting
and receiving data.