Sunbeam Simple Press 3010 Manual Del Usuario página 15

2. Fill the water reservoir with tap water (10 oz.)
and close the water reservoir cover.
3.
Plug the iron into a power outlet.
The power indicator will light.
4. Set the Fabric Select dial to Linen and
allow the iron to heat for 2 minutes.
5. Turn the Steam Control and the Fabric Select
dial to OFF and unplug the iron.
6. Hold the iron over a sink in a horizontal
position.
WARNING: Be careful not to touch the iron's
hot surfaces.
Turn the Steam Control to CLEAN. Water will
7.
begin dripping from the steam vents. To make
sure that all of the water is removed from the
tank, slowly rock the iron side to side and front
to back for 30 seconds. When rocking the iron,
dip the nose of the iron slightly below the rear
of the iron to make certain the water circulates
completely.
13