Cooling Operation - Hitachi RAK-60PPA Manual De Instrucciones

COOLING OPERATION

Use the device for cooling when the outdoor temperature is -10~ 43°C.
If indoors humidity is very high (80%), some dew may form on the air outlet grille of the indoor unit.
1
Press the MODE selector button so that the display indicates
(COOL).
Set the desired FAN SPEED with the
display indicates the setting).
2
(AUTO)
Set the desired room temperature with the TEMPERATURE buttons
(the display indicates the setting).
3
The temperature setting and the actual room temperature may vary
depending on conditions.
Press the (START/STOP) button. Cooling operation starts with a
beep. Press the button again to stop operation. The cooling function
does not start if the temperature setting is higher than the current
START
room temperature (even though the
STOP The cooling function will start as soon as user set the temperature
below the current room temperature.
■ As the settings are stored in the memory of the remote controller, you only
have to press the
■ During AUTO fan, the fan speed automatically changes as below:
When the difference between room temperature and setting tem-
●
perature is large, fan starts to run at HI speed.
After room temperature reaches the preset temperature, fan speed
●
will be changed to lower speed to obtain optimum room temperature
condition for natural healthy cooling.
– 13 –
– 13 –
(FAN SPEED) button (the
(HIGH)
(SILENT) (LOW)
(OPERATION) lamp lights).
(START/STOP) button next time.
(MED)