Transport, Packaging And Storage; Inspection After Transport; Packaging; Storage - Casselin CCF6 Manual Del Usuario

3. TRANSPORT, PACKAGING AND STORAGE

3.1 Inspection after transport

Checking for damage and the completeness of the device must be carried out upon receipt of the package.
In the event of identification of transport damage, refuse or accept the delivered product only with reservations
*. A complaint detailing the defects observed must then be made. The perception of damage is only possible
in the event of a complaint formulated within the prescribed time limits, ie 24-48 hours at most.
* written on the correct paper or digital delivery of the carrier.

3.2 packaging

The packaging of the device must be kept in case of moving, or for a return to the after-sales service. The
inner and outer packaging must be completely removed before using the device. The standards in force in
your country concerning environmental protection must be observed before destroying the packaging.

3.3. Storage

WARNING
The device can be kept in stock, but only in its original, closed packaging.
Storage can be carried out in accordance with these conditions:
• Storage in a dry and non-humid place
• Sheltered from the sun
• Control of the stock greater than 2 months (general condition of the device and all the elements constituting
it)
• No material shaking
• Storage in a closed room and not outside.

4. EQUIPMENT CHARACTERISTICS

* Subject to change
Model
Capacity
Electrical data
Dimensions
Weight

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
CCF6
3-4 Kg
320 W / 230 V
W 305 x D 380 x H 420 mm
6.20 Kg
EN