PACKAGE CONTENTS
Part
A
B
SAFETY INFORMATION
WARNING
• Disconnect power at fuse or circuit breaker before inspecting, installing, removing, or servicing.
• Risk of fire or electric shock: LED retrofit installation requires knowledge of electrical systems of luminaires. If not qualified, do
not attempt to install. Contact a qualified electrician.
• No user serviceable parts inside. To avoid electrical shock, do not disassemble product.
• Not intended for use in emergency light fixtures/exit signs. Not to be exposed directly to weather/water.
• Install retrofit only in luminaires that have the construction features and dimensions shown in drawings.
• To prevent wiring damage/abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Do not make/alter any open holes in enclosure of wiring or electrical components during retrofit installation.
• Maximum number of 12 AWG through branch circuit conductors that are permitted in the junction box is 8.
CAUTION
• The lamp is suitable for use in wet locations. Use only on 120V AC and 60 Hz circuits.
• Min. lamp compartment: 4.0 in. diameter by 5.5 in. height.
• Spacing between retrofit and lamp compartment: 0 in. min.
• The wires through the connection box should not exceed 6 pcs.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
• This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
A
Description
Lamp
Adapter
2
B
Quantity
2
2