Troubleshooting Tips - GE ACSK15 El Manual Del Propietario

Troubleshooting tips.

Save time and money!
Problem
Heater does not start
Heater stopped running
Heater does not heat
as it should
The remote control
(on some models) is
not working
TIMER feature not
working properly
6
Possible Causes
The heater is unplugged.
The fuse is blown/circuit
breaker is tripped.
Power failure.
The current interrupter
device is tripped.
Power interruption or
power failure occurred.
Heater knocked or tipped over.
The current interrupter
device is tripped.
Airflow is restricted.
The temp control may not
be set correctly.
The room may have been cold.
The batteries are inserted
incorrectly.
The batteries may be dead.
A power outage or interruption
occurred.
What To Do
• Make sure the heater plug is pushed completely
into the outlet.
• Check the house fuse/circuit breaker box and replace
the fuse or reset the breaker.
• If a power failure occurs, turn the heater off.
When power is restored, restart the heater.
• Allow the heater to cool, press the RESET button located
on the power cord plug and restart the heater.
• If the RESET button will not stay engaged, discontinue
use of the heater and contact a qualified service technician.
• When the power is restored, restart the heater.
• See the Tip-Over Switch (on some models) section.
• Allow the heater to cool, press the RESET button located
on the power cord plug and restart the heater.
• If the RESET button will not stay engaged, discontinue
use of the heater and contact a qualified service technician.
• Make sure there are no curtains, blinds or furniture
blocking the inlet or outlet of the heater. Make sure
there is at least 3 feet (0.9 m) of space on all sides of
the unit.
• In LO heat or HI heat mode, press the Increase pad.
• When the heater is first turned on, you need to allow
time for the room to warm up.
• Check the position of the batteries. They should be
inserted in the opposite (+) and (–) direction.
• Replace the batteries.
• If the Timer was set before the power outage, it will
need to be reset after power is restored.