Publicidad
Idiomas disponibles
Idiomas disponibles
What's in the Box?
Remote Control
Screws
Connecting Your Sound Bar to Your TV or other sources:
Illustration of the Soundbar connectors for different connections:
Turn on your sound bar:
1. Connect the Power Supplies to Sound Bar then power Insert Power Supplies to an AC outlet.
2. Placing the Soundbar on a flat and solid surface. Hold the Power button
sound bar or Press RED key on the remote control to turn it on. When the Soundbar is switched to standby,
the red dot is turned on.
NOTE*: AUTO OFF Function of LINE IN: If the connected device plays for 60 minutes, the soundbar
automatically turns to Standby to save power.
Hold down II/Mute to disable or enable AUTO OFF function of LINE IN.
Importance Notice for soundbar mounting on the wall:
1)
Wall-mounted installation must be carried out by qualified personnel only.
Incorrect assembly can result in severe personal injury and property damage! (If you intend to install this
product yourself, you must check for installations such as electrical wiring and plumbing, which may be
hidden inside or behind the wall.)
2)
It is the installer's responsibility to verify and confirm that the wall will safely support the total load of the
unit and wall brackets.
3)
Additional tools (not included) are required for the installation.
4)
Do not overtighten screws.
5)
Use an electronic stud finder to check the wall type before drilling and mounting
6)
The proposed height on the wall is 1.0~1.5meters
The control panel on the Soundbar:
Remote control buttons
DSB-2010MK2 IB20210531
Sound bar
Power Supplies
Symbol
/MODE Power On/
Standby
/MUTE disable or enable
AUTO OFF *
Volume up
VOL+ /
Volume down
VOL- /
Aux Cable
EN
LINE IN
LINE IN (AUTO OFF Function*)
DC IN
DC IN
Operation
Hold
Toggle the Mode change: LINE IN
Bluetooth USB Drive
Pause/Play (USB/Bluetooth Mode)
Mute / No Mute
Next USB Drive/Bluetooth Song
Next USB Drive/Bluetooth Song.
User Manual
EN
/MODE at the right side of the
Press
PAGE: 2
Publicidad
