Kohler K-2815 Guia De Instalacion página 9

Install the Lavatory (cont.)
Above-Counter Installations
Cut out the opening by carefully following the pencil line traced
from the template.
CAUTION: Risk of personal injury or product damage. Cast
iron lavatories are very heavy. Get help lifting the lavatory into
place.
Temporarily position the lavatory in the countertop cutout so the
"Kohler" logo is to the back.
Inspect for proper fit.
Remove the lavatory.
Drill the faucet holes.
Install the faucet to the countertop according to the
manufacturer's instructions.
Install the drain to the lavatory according to the drain installation
instructions.
Apply a 1/8" (3mm) bead of sealant around the countertop
cut-out hole. Apply sealant about 1/4" (6mm) away from the
cut-out hole edge.
Carefully position the lavatory in the countertop cutout so the
"Kohler" logo is to the back.
Use care to avoid smearing the sealant bead. Wipe away any
excess sealant with a clean cloth. Fill any voids as needed.
Allow the sealant to cure for at least 30 minutes before
proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Kohler Co. 9 1018374-2-A