Tips For Blending - Beko TBN7400B Manual Del Usuario

2 Operation
WARNING:
• Do not put or blend hot food or liquids in the jug. If you process soup, make sure that the
liquid temperature does not exceed 40°C.
• To process crushed ice, we suggest you to start with three quarters of ice in the jug and
A
add 15 ml of cold potable water.
• Don´t try to crush ice without adding water to the jug.
• Never let the jug blender operate while empty (without food).
• Never let the jug blender operate without the jug on the motor housing.
• Never move or turn the jug after it is properly seated in the place.
• To operate the blender at the low speed, turn the control dial (9) to "1".
• If you want to blend with a higher speed, turn the control dial (9) to the desired speed
C
level (2-3).
• For short pulses of blending with a high speed, turn the control dial (9) to "P". When you
release the control dial (9), the blender will stop and return to "0" automatically.
• If ingredients are to be added during the blending process, then add them through the
opening in the lid (2). To do this, take out the cap/measuring cup (1).
WARNING:
• Never run the blender for longer than 1 minute, otherwise it would overheat.
A
• After running the appliance for 1 minute, let it cool down before using it again.
• Be sure the motor is switched off and has completely stopped before removing the jug
(4) from the motor housing (8).
• Do not place any utensil (scraper, fork, etc.) in the jug while blender is operating.
2.4 Tips for blending
1. To add ice cubes to mixtures while the blender is operating, add one cube at a time through the cap
(1). Wait a few seconds before adding the next ice cube so that the blender can properly blend the ice.
2. To add food while the blender is operating, remove the cap (1) and drop the ingredients through the
opening. Be sure to cut the food into about 2-5 cm pieces to fit through the opening. Replace the cap
(1) when you have finished adding ingredients.
3. When blending solid food, such as raw vegetables, cooked or uncooked meat and fruits always cut
them into no larger than 2-5 cm pieces before placing them into the jug. Blend no more than 2 cups
of these food at a time. This will speed the blending process and reduce wear on the blending blades.
4. Always place liquid ingredients in the jug first, unless a recipe specifically states otherwise.
5. To blend beverages, place all ingredients in the jug at the same time.
6. Avoid overblending. Usually, you will need to blend for a few seconds.
7. Overblending may cause food to become mushy.
Table Blender / User Manual
11 / EN