Technical Specifications - Perel Tools GIK11 Manual Del Usuario

5. Operating Instructions
Refer to the illustrations on page 2 of this manual.
• Flying insects are attracted by the UV light [C] which is mounted near a high voltage electrical
grid [A]. When touching the grid, the insects are electrocuted and fall into the collector [B].
IMPORTANT: Never touch the metal grid with your bare hands! If you need to clean the tray,
follow the safety instructions carefully.
a. Discharging the device before maintenance
• Unplug the device from the mains.
• Use a screwdriver with an insulated handle. Make sure you only hold the screwdriver by
the handle.
• Short-circuit the 2 wires of the inner metal grid by gently touching them simultaneously
with the metal shaft of the screwdriver. A spark may arise. Repeat this manipulation until
no more sparks arise.
b. Cleaning the tray
• Remove the tray by sliding it out of the device.
• Clean the tray with a brush.
c. Cleaning the device / replacing lamps and starters
• Clean the insect killer regularly with a dry, clean cloth and plastic brush. Do not submerge
into any liquid.
• Make sure no dust accumulates on the UV lamps as this will greatly reduce their
effectiveness.
• Unplug the device from the mains.
• Discharge the device (see a.).
• Release the two nuts on the top (see arrows) and lift the top part (with the lamps and high
voltage grid).
• Only use a plastic brush to clean the high-voltage grid. Brush gently to avoid damage.
• When the lamps are worn, they must be replaced with a similar type (see technical
specifications)
• Remove a UV-lamp by gently turning it a quarter turn and pull it upwards out of the
sockets.
• Place a new UV-lamp into the socket and turn it a quarter turn to secure it.
• To replace a starter, first remove the UV-lamp that covers it.
• Turn the starter a quarter turn and pull it out of the socket. Insert a new starter with the
same specifications into the socket and turn it a quarter turn to secure it.
• Gently slide the top part with the high voltage grid back into the outer grid.
• Place the washers back over the bolts and secure with the nuts (2x).

6. Technical specifications

input voltage
grid voltage
effective area
dimensions
weight
lamp
Use this device with original accessories only. Velleman nv cannot be held responsible
in the event of damage or injury resulted from (incorrect) use of this device. For more
info concerning this product, please visit our website www.perel.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
23.11.2009
GIK11
230VAC / 50Hz
1800-3000V
100m²
532 x 320 x 140mm
4.2kg
UV-A tube 2 x 15W (spare lamp: GIK09LAMP)
4
©Velleman nv