Publicidad
IMPORTANT INFORMATION
• Hot and cold water inlet pressures should be equal.
• Operating static pressure is 150—500kpa. If pressure exceeds this, then an approved
pressure limiting valve must be fixed.
• Pipework must be flushed out prior to installation of the mixer. Damage caused to the
mixer by debris coming through the pipework is not covered under warranty.
• Installation should comply to AS/NZS3500 or the relevant local requirements.
• Maximum hot water temperature is 75°.
• Not suitable for gravity feed applications.
MAINTENANCE AND CARE
• Using a soft cloth with a mild detergent or soap is all that is required to clean surfaces.
• Do not use abrasive cream cleaners or citrus based cleaning products. These will
damage the surface.
• Aerator may be removed and cleaned should it become blocked.
Installation and Care Instructions
WM-004006
AS/NZS 3718-2005
Zucchetti Rubinetteria S.p.A
Publicidad
