Technical Details - Vaude Power Ferret UL 2P Manual Del Usuario

• Tent pole shock cords can be retightened if necessary (elasticity can wear
out in very cold conditions or due to aging). To do this first remove the end
cap and then untie the knot in the cord. Retie the knot further up the cord
and replace the cap.

TECHniCal DETailS:

Depending on tent models, VAUDE tents feature the following:
fEaTUrES:
Silicone Seam Seal:
VAUDE is the only manufacturer to successfully factory seam seal siliconised
tents for full waterproof protection!
Siliconized:
• Increases tent life by 20% - a triple coating reflects damaging UV radiation
to a much greater degree than standard treatments.
• 8-times greater tear resistance – siliconized fabrics attain a tear resistance
of 8-11 kg compared to 1.3 kg of PU coated fabrics.
• Excellent water beading properties – water simply beads on the surface.
• Retensioning – the nylon carrier material swells up when damp or wet.
The tent needs to be retensed if rain/snow initiate.
• Sealing – siliconized materials cannot be factory seam sealed (exception:
VAUDE Silicon Seam Seal). When camping in extremely rainy conditions
we recommend sealing all seams by hand with a silicon seam sealer.
flY:
Super lightweight 20D Polyamide ripstop 280T Si/Si;
3,000 mm water column.
• Good tear resistance thanks to extremely fine, super lightweight yet high-
tenacity polyamide thread with reinforced cross threads.
• SI - Triple layer silicon coating on both inner and outer sides for maximum
tear strength and water beading effect, as well as increased UV resistance.
innEr TEnT:
30D Polyester ripstop 285T.
• 285T – tightly woven ripstop polyester. Wind, sand and snow proof with
GAL_TENT_Power_Ferret_UL_2P.indd 13
PowEr fErrET Ul 2P 13
08.08.2011 11:54:24