Unpacking Instruction; Power Supply - Beamz Rage 1800 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Attention:

The suspension construction should be such that it can support 10 times the weight of the product per hour.

Always use the supplied mounting bracket to hang the product.

The product should be attached to the supplied mounting bracket using a mounting clamp (not included).

The product must always be secured by means of a safety cable.

Make sure that no individual stands or can walk under the product during installation, repair, etc.

The user is responsible for the product, its installation and the safety of the whole. If the user is not able to do so, an
external expert must always be called in to check the product and take responsibility.

The user must have the product and the installation checked at least once a year by an external expert for safety,
technical operation, etc. The user must also have the product and the installation checked by an external expert at
least once a year.

Keep out of the reach of children.

For indoor use only.
DISPLAY
Via the Menu key, you can adjust the desired settings. After pressing the menu, the display shows the following settings:
1. Man Vol Out xxx%.
Adjust the manual volume output within the range of 0% to 100% by means
of the Up/Down keys.
2. Interval Set xxxS
Adjust the interval between 1 to 100S by means of the Up-/Down keys.
3. Duration Set xxxS
Adjust the duration between 1 to 100S.
4. Volume Out xxx%
Adjust the volume output during the timer function within the range of 0-
100%
5. DMX 512 #xxx
Adjust the DMX address for DMX control.
6. Wind For Class xx
NO FUNCTION for this model.
7. Angel Set xx%
NO FUNCTION for this model.
4
CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!