OUKITEL WP Serie Manual De Instrucciones página 26

Manufacturer's Name: SHENZHEN YUNJI INTELLIGENT
TECHNOLOGY CO.,LTD
Smart Phone
Model number: WP9
Operating Temperature: -10° C to 40° C
This device was tested for typical body-worn operations. To
comply with RF exposure requirements, a minimum separation
distance of 0mm must be maintained between the user's body
and the handset, including the antenna. Third-party belt-clips,
holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that
do not meet these requirements may not comply with RF
exposure requirements and should be avoided. Use only the
supplied or an approved antenna.
This device in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU. All essential
radio test suites have been carried out.
1.Use careful with the earphone maybe possible excessive
sound pressure from earphones and headphones can cause
hearing loss.
2.CAUTION : RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
3.The product shall only be connected to a USB interface of
version USB 2.0
4.Adapter shall be installed near the equipment and shall be
easily accessible.
5.The plug considered as disconnect device of adapter
6.The device complies with RF specifications when the device
used at 0mm form your body
49
This device complies with part 15 of the FCC Rules. Operation is
subject to the condition that this device does not cause harmful
interference
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Mobile Phone meets the government's requirements for exposure
to radio waves. The guidelines are based on standards that were
developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons
regardless of age or health.
requirements, use accessories that maintain a 10mm separation
distance between the user's body and the back of the handset. The use
of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do
not satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply
with RF exposure requirements, a minimum separation distance of
10mm must be maintained between the user's body and the handset,
including the antenna. Third-party belt-clips, holsters, and similar
accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
FCC ID: 2ANMU-WP9
50