Schön TL-7522HC-W Instrucciones De Instalación página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
DO NOT USE IN-TANK CLEANERS. Products containing chlorine (calcium hypochlorite) can seriously damage tank fittings
potentially causing leaks, excessive water use, and property damage. The manufacturer shall not be responsible or liable
for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hypochlorite).
NOTE
Improper care may cause the warranty to become invalid.
1.
When cleaning your toilet and toilet seat, wash it with mild soapy water. Rinse thoroughly with clean water and
dry with a soft cloth.
2.
Avoid detergents, disinfectants, or cleaning products in aerosol cans. NEVER use abrasive scouring powders on
your toilet or toilet seat.
3.
Some bathroom chemicals and cosmetics may cause damage to the toilet seat's finish, so test your cleaning
solution on an inconspicuous area before applying to the entire surface.
PROBLEM
The toilet is flushing poorly, and the water level is
below the water line mark.
Water is continuously running.
1. Turn o the water supply to the toilet and flush the tank completely. Towel or sponge any remaining water from the
tank and bowl.
2. Disconnect and remove the old water supply lines.
3. Remove the tank from the bowl by removing the old tank-to-bowl hardware.
4. Remove the bowl from the floor by removing the bolt caps and floor bolt nuts.
5. Remove the floor bolts from the toilet flange and clean old wax, putty, and sealant from the base area. (Temporarily
plug the floor flange with a towel or cover to block sewer gases from escaping.)
NOTE
Ensure that the mounting surface is clean and level before the new toilet is installed.
Contact Schön at (800) 880-8164 or visit www.schonsimplymodern.com. Copyright ©2015, World Imports Decorative Plumbing. All rights reserved.
1-Piece High Efficiency Toilet
Care & Cleaning / Troubleshooting / Pre-Installation
SOLUTION
1.
The shut-o valve may not be completely open.
Verify that the the shut-o valve opens fully.
2.
Ensure the water supply line is not twisted.
3.
The floater cup of the fill valve may be obstructed.
Adjust the fill valve to allow free movement.
1.
Water may continuously run if the flush seal is not
completely closed. Check to see if there is any
obstruction in the flush seal.
2.
The push button rods may be too long. Shorten the
rods by loosening the lock nuts, adjusting the rods to
the proper length and tightening the lock nuts.
When installed the push button rods should just touch
the flush valve buttons without depressing them.
PAGE 3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tl-7522hc-biTl-7522hc-bk692 406692 403692 404

Tabla de contenido