Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

GMRC-05
GM Class II data bus interface
1996-2002
applications
chevrolet
Equinox
pontiac
Torrent
Kit Features
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power), if equipped
• Used in non-amplified systems or when replacing amplified systems
• Retains all warning chimes through onboard speaker
interFace components
• GMRC-05 data interface
• 10-pin to 24-pin GM harness with stripped leads
tools required
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
METRA. The World's best kits.™
Installation Instructions for GMRC-05
2005-2006
2006
1-800-221-0932
connections to be made
From the 10-pin harness:
• Connect the red wire to the ignition wire of the aftermarket radio.
• Plug the 10-pin harness into the GMRC-05.
From the 24-pin harness:
• Connect the Yellow wire to the radio's 12-volt battery or memory wire.
• Connect the black wire to the radio's ground wire.
• Connect the orange/White wire to the illumination wire of the aftermarket
radio. If the aftermarket radio has no illumination wire just tape off the
orange/White wire.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/black wire to the radio's left rear negative speaker output.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION

Publicidad

loading

Resumen de contenidos para Metra GMRC-05

  • Página 1 GM Class II data bus interface From the 10-pin harness: 1996-2002 • Connect the red wire to the ignition wire of the aftermarket radio. applications • Plug the 10-pin harness into the GMRC-05. chevrolet From the 24-pin harness: Equinox 2005-2006 •...
  • Página 2 • Mount the GMRC-05 in a location where the internal speaker will be heard. Note: If the chime volume of the GMRC-05 is too loud you will need to remove the cover and cut the solder connection where the arrow points to on the circuit board (between the holes on the board).
  • Página 3 Desde el arnés de 10 pins: 1996-2002 • Conecte el cable rojo con el cable de ignición del radio de mercado secundario. ApLICACIonES • Conecte el arnés de 10 pins en el GMRC-05. CHEvRoLET Desde el arnés de 24 pins: Equinox 2005-2006 •...
  • Página 4 • Reconecte la terminal negativa de la batería. • Cicle la llave, encendiendo la ignición durante 30 segundos. Después apague Nota: Si el volumen de los tonos del GMRC-05 es demasiado alto, deberá quitar la tapa y y encienda de nuevo para probar el radio.