Schumacher Electric Instant Power IP-95C Manual Del Usuario página 8

12V DC ESTIMATED RUN-TIMES
PPLIANCE TYPE
A
Cell phone
Fluorescent light
Radios, fans
Depth finder
Camcorder
Electrical tool
Electric cooler
Car vacuum,
air compressor
NOTE: Actual time may vary. Times are based on the
internal battery being fully charged.
8.3 Using the USB port
The USB port provides up to .5A at 5V DC.
1. Ensure the battery clamps are
securely clipped on the storage
holders.
2. Turn the Instant Power ON
3. Plug your device into the USB port.
4. When finished using the USB port,
turn the switch to the OFF position.
5. Charge the Instant Power.
8.4 Using the air compressor
WARNING: Read the instructions of the
product being inflated before using the
compressor. Avoid overinflation; do not
exceed the manufacturer's recommended
pressures. Do not leave the air compressor
unattended during use.
NOTE: Wrap cleats are provided for
convenient storage of the air compressor
9. MAINTENANCE INSTRUCTIONS
9.1 After use and before performing
maintenance, unplug and disconnect the
Instant Power (see sections 3 and 4).
9.2 Use a dry cloth to wipe all battery
corrosion and other dirt or oil from the
battery clips, cords, and the Instant
Power's case.
10. MOVING AND STORAGE INSTRUCTIONS
10.1 Store the Instant Power in an upright
position.
10.2 Store inside, in a cool, dry place.
10.3 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the Instant
Power are live and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
All manuals and user guides at all-guides.com
EST ESTIMATED
WATTAGE RUN TIME
4 watts 36 hrs
4 watts 36 hrs
9 watts 16 hrs
9 watts 16 hrs
15 watts 9.6 hrs
24 watts 6 hrs
48 watts 3 hrs
80 watts 1.8 hrs
.
• 8 •
hose. Wrap the hose around these cleats
when the hose is not in use.
1. Remove the air compressor hose from
the storage cleats.
2. Connect the adaptor to the valve
stem and close the thumb latch. If
necessary, use one of the additional
adaptors.
3. Turn ON the compressor switch and
inflate to the desired pressure or
fullness.
4. When the desired pressure is
reached, turn the compressor power
switch OFF, open the thumb latch and
remove the connector from the valve
stem.
5. Do not run for more than 10 minutes.
Allow the Instant Power to cool down
for 10 minutes before using again.
6. Recharge the unit before storing.
NOTE: To prevent overheating, the
compressor has built-in thermal protection
that will turn the compressor off before it
overheats. If the compressor shuts off,
wait a few minutes and it will automatically
restart when the compressor cools.
NOTE: The air compressor is rated for
150 PSI.
Estimated time for inflating
Vehicle tires 13-16"
Bike tires
Sports balls
These times are approximate. Use the air
compressor gauge to ensure the proper
pressure has been reached. Do not overinflate.
9.3 Ensure that all of the Instant Power's
components are in place and in good
working condition, including the plastic
boots on the battery clips.
9.4 Servicing does not require opening the
unit, as there are no user-serviceable
parts. All servicing should be performed
by qualified service personnel.
keep the clips on the storage holders when
not using them to jump start a vehicle.
10.4 If the Instant Power is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and Instant Power. Failure
to do so could result in personal injury or
property damage.
6-24 minutes
1-3 minutes
30 seconds