Charging The Battery Pack - Toro 88500 Manual Del Usuario

Charging the Battery Pack

1. Turn the battery upside down and line up the
battery terminal with the slot in the charger
(Figure 1 and Figure
1. LED indicators
1. LED indicators (level of
charge)
2. Release button
2. Slide the battery into the charger until it clicks
into place.
3. To remove the battery, press down on the
release button and slide the battery backwards
out of the charger.
2).
Figure 1
2. Insert battery here
Figure 2
3. Battery terminal
4. Refer to the table below to interpret the LED
indicators on the battery charger.
LED COLOR
Top
Red
Red
Red
Inserting the Battery into
the Trimmer
1. Align the tongue of the battery pack with the
cavity in the handle housing
g019895
Hedge trimmer handle shown
1. Cavity
2. Tongue
2. Grasp the trimmer handle.
3. Push the battery pack into the handle until the
latch locks into place.
g016223
Important:
charged when it is purchased. Before using
the trimmer for the first time, place the
battery pack in the charger and charge it until
the LED indicators turn green. Make sure to
read all safety precautions. With regular use,
it will need shorter charging time. If storing
for a prolonged period of time, remove the
battery. When ready to use again, charge the
battery pack until the LED indicators turn
green.
3
Bottom Indicates:
Red Battery is charging
Green Fully charged
Orange Battery is too
warm: Remove
for approximately
30 minutes
(Figure
Figure 3
3. Latch
The battery pack is not fully
3).
g016329