Concept NO8020 Manual Del Usuario página 25

EN
PRODUCT ASSEMBLY INSTRUCTIONS
1. Open the locks on the telescopic rods and lock them in the desired position.
2. Attach the rods to the base.
3. Attach the holder to the ironing board.
3 Lock
1 Unlock 2 Pull out
4. Open the locks on the board and slide them onto the telescopic rods. Lock them.
5. Use the button on the bottom side of the board to set the desired position.
6. Place the ironing head in the holder.
Unlock
Lock
Important safety information:
• Always place the steam head in the holder. Never let it lay loose. This could result in accidental personal injury or
property damage.
• Never attempt to wind or otherwise bend the steam hose using excessive force.
• Never carry the appliance by pulling on this hose.
STEAMING GARMENT INSTRUCTIONS
1. Fill the water tank and insert it back into the base.
2. Plug in the appliance. Press the ON/OFF button and select the desired function according to the fabric type.
3. Wait approximately 48 seconds.
4. When steam starts to come out of the head, the appliance is ready for use.
2 On
48
CAUTION:
Watch your hands
when turning the
ironing board.
Important notice:
To ensure maximum lifetime of the appliance, we strongly recommend using only distilled or
•
demineralized water. If you live in an area with hard water, limescale will clog the appliance and reduce
its efficiency!!!!!
• Use only cold water (never hot)!
• The appliance is equipped with an empty water tank indicator. If the Lacking Water indicator lights up, refill the
water tank immediately. If you hear a beep sound, the water tank is not properly inserted.
IRONING GARMENT INSTRUCTIONS
1. Fix the adjustable ironing board in the desired position.
2. Select the desired position of the ironing head.
3. Select a suitable ironing method.
1
AFTER USE
1. Use the main ON/OFF switch to switch off the appliance.
2. Disconnect the appliance from the mains.
3. Let the appliance cool down for at least 30 minutes.
After each use, remove the water tank and empty it!!!!
4.
5. Pull out the drain plug and allow the remaining water to drain
into the container.
6. Drain the remaining water through the drain plug at the bottom
of the appliance.
7. Shorten the telescopic rods and store the appliance.
TROUBLESHOOTING
This chapter lists the most common problems you may encounter when using the appliance. If the instructions below do
not help you to solve the problem, contact the Jindřich Valenta - Concept company service department.
NO8020 NO8020
2
3
1 Off
EN
49