Protection Of The Environment - Rowenta PRO 2000 CV7115F0 Manual De Instrucciones

5 - CLEANING:
CAUTION: always unplug your appliance before cleaning.
accessories in water.
• Carefully dry all parts you have just cleaned.

6 - PROTECTION OF THE ENVIRONMENT

At the end of the life of your product, it should go to a
specially-adapted waste recycling centre.
WIRING INSTRUCTIONS - FOR U.K. ONLY.SAFETY NOTES - FOR REWIREABLE OR
MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should
the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off
if it is a moulded on plug) and an appropriate one fitted. Warning : dispose of a plug that
has been cut from the power supply cord, as such a plug is hazardous if inserted in a
live 13 A socket outlet elsewhere in the house.
Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover
is omitted or lost until a replacement is obtained - make certain that only the correct fuse
cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the same as the
colour insert in the base of the plug, or as directly by the embossed wording on the
base of the plug.
If the detachable fuse cover is lost, a replacement may be
purchased from an approved Rowenta Service Centre (see
enclosed Service Information leaflet). Information for supply
may also be obtained from the plug manufacturer.
U.K ONLY - FITTING A PLUG
Important : the wires in this lead are coloured in accordance with the following codes Blue,
Neutral, Brown, live. Please read the instructions given below before connecting the cord
to a plug. If in doubt, please consult a qualified electrician.
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows :
• the wire which is coloured BLUE must be connected to the terminal which is marked with
the letter " N " or coloured BLACK.
• the wire which is coloured BROWN must be connected to the terminal which is marked
with the letter " L " or coloured RED.
Neither core is to be connected to the earth terminal of a three-pin plug.
This appliance requires a 13 fuse ASTA approved to BS 1362.
• Your hair dryer requires very little attention.
You can clean it, together with its accesso-
ries, using a slightly damp cloth to remove
hair or impurities trapped in the rear grid.
• Never clean your appliance with alcohol.
• Never immerse your appliance or its
Blue or
N
black
GB
Brown
L
or red
Fit correct
fuse
Use cable
gripper