DeWalt DXV20P Traducido De Las Instrucciones Originales página 19

English
BLOWING FEATURE (Fig. C)
WARNING:
To avoid injury to bystanders, keep
them clear of blowing debris.
The vacuum contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the hose into the blowing port.
3. Turn vacuum "ON".
STORAGE (Fig. A)
1. Empty dust tank, refer to
instructions.
2. Clean the vacuum inside and outside. refer
to CLEANING.
3. Clean or replace lters, refer to FILTER.
4. Store the hose and the power cord, as
Fig. A. Place the appliance in
shown in the
a dry room and secure it from unauthorized use.
OPTIONAL ACCESSORIES
WARNING:
Since accessories, other than those
offered by D WALT, have not been tested with this
E
product, use such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
recommended accessories should be used with
this product.
CLEANING
To keep the wet/dry vacuum looking its best, clean
the outside with a cloth dampened with warm water
and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
TROUBLESHOOTING
:
WARNING
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be xed without calling
customer service.
TO EMPTY DUST TANK
WALT
E
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the oor
nozzle, extension wands, hose
or lter.
Replace the disposable dust bag.
Suction capacity
Check for proper installation of
decreases
the lter.
Clean or replace the lter.
Empty dust tank, refer to
THE TANK
INSTRUCTIONS.
Thermal overload has been tripped:
1. Turn the vacuum off and
2. Empty the dust tank, if needed.
Vacuum stops
3. Allow the unit to cool.
running
4. Plug the power cord into an
Check for proper installation of the
Ensure lters are not damaged;
Dust comes out
replace if necessary.
while vacuuming
Ensure lter seals are in place and
are secure.
Check the t of the vacuum head.
If the supply cord is damaged, it must
WARNING:
be replaced by the manufacturer, its service agent or
a similarly quali ed person in order to avoid a hazard.
TOOL GUARANTEE
3
YEAR
LIMITED
GUARANTEE
17
SOLUTION
TO EMPTY
OPERATING
under
disconnect vacuum cleaner from
power source.
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
lters.