Fiap Wallskim Active Slim Manual De Instrucciones página 6

FIAP WallSkim Active Slim
Important
The water-level of the pond or pool cannot be lower than 30 mm under the top edge of the skimmer-
flange (equals a maximum water level of 15 mm – 20 mm under the closed skimmer-weir).
Always pay attention to the maximum water-level! (see figure)
To guarantee stability the lid of the surface-suction device and the waste-basket have to be mounted
while the device is built in or encased in concrete. To avoid material pollution of the stainless steel
threads you should first screw the flat head screw, with a cross slot M5 x 14 mm, into the stainless
steel flange. If the stainless steel threads pollute anyway, you can easily clean them with a M5
screwplate.
The pond-foil or the pond-mat must be removed with a hole punch at the grommets of the screws, to
prevent pond-foil or pond-mat from getting into the flange.
Before mounting the counterflange the skimmer-weir must be installed on the side of the tank.
One of the two flat gaskets has to be mounted between the surface-suction device and the pond-foil,
the second one between the pond-foil and the counterflange on the side of the tank.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
11
www.fiap.com
FIAP WallSkim Active Slim
Cleaning and maintenance
Read security instructions first! The FIAP WallSkim Active Slim requires very little maintenance and it
is very animal-friendly. A user-friendly handle allows simple removing and cleaning of the waste- and
leave-basket. Clean the waste-basket without chemical cleaners, regularly and if necessary. Never add
the water care products directly into the device ( tablets into the dosage-swimmer or dosage-station, all
others dissolve first).
Storage and overwinter
The device has to be turned off when water temperatures under 8° C or latest when the first frost
comes. Lower water level to 15 cm under the skimmer-opening and remove the waste-basket. Empty
out the device, clean it properly and check for possible damage. The storage place has to be
inaccessible for children. Cover the device so that no rain-water will get into it. Empty out all hoses,
pipes and connections. The guarantee covers no frost-damage.
Wearing parts
The FIAP WallSkim Active Slim waste-basket and the EPDM gasket are wearing parts and are not
under guarantee.
Disposal
The device must be disposed by the national laws. Please ask your specialist dealer.
Failures
Problem Cause
The device is not cleaning to Not enough streaming at the
your satisfaction. suction-opening.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
Solution
- Support the streaming with a
waterfall or inlet nozzles.
- Remove plants or stones in
front of the suction-opening.
12
www.fiap.com