Resumen de contenidos para Little Tikes First Prep Kitchen
Página 1
First Prep Kitchen™ ASSEMBLY INSTRUCTIONS #654039M Adult assembly required. Approx. assembly time: 30 min. Look for video of assembly at littletikes.com/videoinstructions XIM654039-R1 - 9/20...
Página 2
• Clear a flat surface to lay out all the materials so everything is close at hand. • You will need a Phillips head screwdriver (not included) to assemble the First Prep Kitchen™. - When installing screws, be sure screws are tightened snugly, but do NOT OVERTIGHTEN.
Página 3
The Little Tikes Company makes fun, high quality toys. We warrant to the original purchaser that this product is free of defects in materials or workmanship for one year * from the date of purchase (dated sales receipt is required...
Página 4
Some packages of hardware may have extras pieces. ” (1,27 cm) (12) Actual size Questions? We’re here to help. Little Tikes customer service team at 1-800- 321-0183. Hole plugs Front wall -- left side (1) Front wall -- right side (1) Top back wall (1)
Página 5
Refrigerator door handle (1) Burner module (1) Oven door (1) Sides (2) Refrigerator door (1) Faucet (1) Towel bar (1) Faucet fastener (1) Knobs (2) Slide-on shelves (2) Oven rack (1) (1) Decal sheet is located in the hardware pack. Illustrations are for reference only.
Página 6
Ready...let’s start! Tool required (not included) Battery installation MUST be completed by an adult: 1. Using a Phillips screwdriver (not included) remove the screws and battery compartment cover (1) located on the burner module (K). 1.5V AA/LR03 2. Install three (3) fresh AA alkaline batteries (not included), making sure 1.5V AA/LR03 the (+) and (-) ends face the proper...
Página 7
Two parts make one First, place the Left side - front wall (part B) onto the Right side - front wall (part A). Second, secure using (2) ” (1,27 cm) screws. " (1,27 cm) (view from the back)
Página 8
Get snappin’ Snap (1) side (part J) onto the assembled front walls. Make sure ALL (4) tabs line up before snapping! WAIT! If they don’t line up - flip the side around. Snap (1) side (part J) onto the opposite side of assembled front walls.
Página 9
Flip it Turn the unit upside down and snap on the bottom platform (part F). Align indents Get cookin’ First, fit the burner module (part K) into the countertop (part G). Second, flip the countertop over and secure using (2) ”...
Página 10
SINK it! Snap the sink (part I) into the countertop. The countertop is a SNAP! Turn the unit right side up and snap on the countertop (part G). WAIT! Make sure ALL the tabs line up and SNAP! If they don’t, the countertop may appear wobbly.
Página 11
You gotta have a faucet! Insert faucet (part N1) into the countertop and secure by attaching the faucet fastener (part N2) under the countertop from the back of the unit. (view from the back) Sticker it up Time to apply the decals 1 & 2 to the top back wall (part C).
Página 12
Get down with it Fit the top back wall (part C) onto the assembled countertop. Top it off First, fit the top shelf (part H) onto the back wall.
Página 13
Top it off - cont. Second, secure using (6) ” (1,27 cm) screws. " (1,27 cm)
Página 14
Slide in your shelves Insert the (2) slide-on shelves (part R) into the side of the top. Shelves may need a little push! Handle it First, insert the refrigerator door handle (part M1) into the refrigerator door (part M2). Second, secure using (2 ) ”...
Página 15
Sticker it up Decal Time to apply decal 4 to the refrigerator door (part M2). 1. Partially pull back the top of decal 4. 2. Line up decal corners to the top corners on the door. 3. As you pull away backing, press down, smoothing the decal from the center to the edge.
Página 16
Pop it on...again Pop in the left side of oven door (part L) into the kitchen. Then, slide down right side of oven door until it also pops into the kitchen. Insert oven rack (part Q) into the kitchen oven.
Página 17
This is tricky Snap on side table support (part E). Choose which side you want to install the shelf! Hole plug Locate (2) holes on this side of the unit. Insert a hole plug into each hole. Long Short post post (There is a long post and a short post.
Página 18
Swing it in Pop-in the side table (part D) into countertop. Still more to swing Swing table support upward and snap it into the underneath of the side table.
Página 19
Turn it on PUSH in (2) knobs (part O) onto front kitchen panel. Almost there! Insert towel bar (part P).
Página 20
Final 2 decals! Apply decals 3 and 5. Decal 5 Cell phone (1)
Página 22
5. Si les piles sont vides ou usées, retirez-les du Outil requis (non fourni) : Tournevis produit. Pièces 6. Jetez les piles en suivant les consignes; ne les enterrez pas. Ne jetez pas les piles au feu, car elles A. Paroi avant - côté gauche (1) M1.
Página 23
à compter de sa date d’achat (le reçu d’achat daté est exigé comme preuve d’achat). Au titre de réfrigérateur (partie M2). 1) Retirez partiellement le la présente garantie, la seule responsabilité de The Little Tikes Company et le seul recours se limitent dos du haut de l’autocollant 4. 2) Alignez les coins de au remplacement de la pièce défectueuse ou au remplacement du produit.
• Necesitará un desarmador Phillips (no está incluido) • Para limpiar mejor el producto, usa una tela con para ensamblar First Prep Kitchen™. agua y jabón suave o toallitas limpiadoras para la - Al instalar los tornillos, asegúrese de que los piel, las manos o el rostro.
4. Cuando el juguete no se usa durante un período Llame a nuestro equipo de servicio al cliente de de tiempo extendido, retire las baterías para Little Tikes al 1-800-321-0183. impedir una posible fuga y daño a la unidad. Requiere herramientas (no se incluyen) 5.
Página 26
(se requiere el recibo de compra fechado como prueba). A exclusiva elección de (1.27 cm). la compañía Little Tikes, el único remedio disponible bajo esta garantía será el reemplazo de la parte defectuosa del producto o el reemplazo del producto. Esta garantía es válida solamente si el producto Paso 14: Coloque las etiquetas ha sido montado y mantenido según las instrucciones.