Installing The Mini-Bowl And Mini-Blade - KitchenAid KFP1356 Instrucciones

ASSEMBLING THE FOOD PROCESSOR CMD + SHIFT CLICK TO CHANGE COPY
Install the work bowl cover, being sure
3
it locks into place.

Installing the mini-bowl and mini-blade

Place the mini-bowl inside the work
1
bowl over the power shaft. Rotate the
mini-bowl until the tabs on the top edge
of the bowl drop into the indents on the
top of the work bowl.
Install the work bowl cover, being sure
3
it locks into place.
16
W10782139A_EN_v04.indd 16
NOTE: The multipurpose blade features an
internal seal that fits tightly over the center
of the work bowl.
Insert the drive adapter into the mini-
2
blade, and place on the power shaft. It
may be necessary to rotate the blade
until it falls into place. Press down firmly
to lock it into place.
To remove the mini-bowl after
4
processing, remove the mini-blade by
pulling straight up on the cap. Then lift
the bowl straight up and out, using the
two finger grips located along the top
edge of the bowl.
C O
2/26/15 2:32 PM