Turning Off The Machine; Removal Of Integral Filter; Emptying The Machine; Machine Without Drain Pump - Bobeck HGS 540 Manual Del Usuario

INSTRUCTION MANUAL FOR DISHWASHERS
• Press the button ON/OFF (1). The machine will shut off. On the DISPLAY (4), the middle segments
will stay on to show that the machine is powered up. Then, always disconnect the main power supply
up the line from the machine.
1. Turn off the machine.
2. Place the wash and rinse arms at a right angle to the edge of the door (
3. Raise each semi-filter, grasping it by the handle.
Turn off the machine. Disconnect the electricity and shut off the water.
Remove the integral filter (
Extract the overflow by pulling upwards (
If necessary, extract the tub filter and clean (
1. With the machine on (
until you see the message 'DRAIN'.
2. Remove the integral filter (
3. Extract the overflow (
4. Press the START button (3).
5.
The machine turns off at the end.
If necessary, extract the tub filter and clean (
Remove the basket from the machine.
With the machine on (
until you see the message 'DRAIN'.
Press the START button (3).
The machine will start a special wash sequence begins which makes it possible to clean and
drain the tub.
The machine turns off at the end.
If necessary, extract the tub filter and clean (
Fig.6 A
Fig.7 C
Fig.4
Fig.6 A
Fig.7 B
), close the door.
Fig.7 C

4.7.3 Machines with partial draining: self-cleaning cycle and final draining

Fig.4
), press the PROGRAMME SELECTION button (2)
Fig.7 C

4.7.1 Machine without drain pump

).
Fig.7 B
), and wait for the tub to drain completely.
).
), press the PROGRAMME SELECTION button (2)
).
).
).

4.5 Turning off the machine

4.6 Removal of integral filter

Fig.6
).

4.7 Emptying the machine

4.7.2 Machine with drain pump

Page 7 of 12
GB