Publicidad
Idiomas disponibles
Idiomas disponibles
5.1
Installing diamond slitting discs
Pin wrench
@
Clamping nut
;
Spacer ring
=
Diamond slitting disc
%
1. Lay the tool on its left side (spirit level facing up).
2. Press and hold down the carriage release button to unlock the carriage.
3. Swing the carriage out and let go the carriage release button.
4. Fit the clamping flange onto the spindle.
5. Place the first diamond slitting disc on the clamping flange. Make sure that the direction-of-rotation arrow
on the slitting disc points in the same direction as the direction-of-rotation arrow on the power tool.
Comply with the instructions for selecting suitable diamond slitting discs. → page 7
6. Select the correct spacer rings for the width of the slit and place them on the clamping flange.
The width of the slit is equal to the thickness of the two diamond slitting discs and the spacer rings
inserted between them. The widths of the spacer rings are 4 mm, 7 mm, 13 mm and 22.5 mm.
7. Place the second diamond slitting disc in position.
WARNING
Risk of injury! The diamond slitting discs can work loose in operation if the complete set of spacer rings is
not installed on the clamping flange.
▶ After installing the second diamond slitting disc, always place all the remaining spacer rings on the
clamping flange.
8. Place the remaining spacer rings on the clamping flange.
9. Press and hold down the spindle lock button.
10. Screw on the clamping nut and tighten it securely with the pin wrench. Release the spindle lock button
and remove the pin wrench.
11. Pivot the carriage towards the body of the machine until it engages in position.
5.2
Connecting the vacuum cleaner
▶ Connect the vacuum cleaner hose to the vacuum cleaner hose connector of the slitting tool.
6
Types of work
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work
is in progress, immediately disconnect the device and the cord from the electricity supply. Do not touch the
damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
6.1
General notes on working with the slitting tool
▶ Select the right type of diamond slitting disc for the material to be cut.
▶ If cutting performance drops, check whether the diamond slitting discs are badly worn and need to be
replaced or sharpened.
▶ Make vertical cuts from top to bottom by preference.
▶ It is not possible to cut curves.
▶ Guide the slitting tool without turning or tilting it.
8
English
2
Clamping flange
&
Arbor (on the slitting tool)
(
Direction-of-rotation arrow on casing
)
2208336
*2208336*
Publicidad
