Rockwell RK2852K2 Manual De Instrucciones página 12

HIGH EFFICIENCY CORDLESS DRILL DRIVER
HIGH EFFICIENCY HAMMER DRILL
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Checking the battery charge
condition
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch
and disconnect tool from power source when
changing accessories. Always ensure the bit is secure
before starting the tool. Damage to the Chuck or a loose
bit may cause possible personal injury.
-- Removing the bits
-- Inserting the bits
Assembling the belt hook and
bit clip
OPERATION
FORWARD/REVERSE
ROTATION CONTROL
WARNING: Never
change the direction
of rotation when the chuck
is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
DRILLING, SCREWDRIVING,
HAMMER DRILLING
OPERATING THE ON/OFF
SWITCH
WARNING: Do not
operate for long periods
at low speed because excess
heat will be produced internally.
12
Figure
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B1
See Fig. B2
See Fig. C1, C2,
C3,C4
See Fig.D1, D2, D3
See Fig. E
See Fig. F
See Fig. G
LED light indicator
Before operation, the LED light
will be activated when the On/
Off switch is slightly depressed,
and will automatically turn off
20 seconds after the On/Off
switch is released.
The tool and battery are
equipped with a protection
system. When the LED Light
is quickly flashing 3 seconds
and turn off, the system will
automatically cut off power to
the tool to extend battery life.
The tool will automatically stop
during operation if the tool and/
or battery are placed under one
of the following conditions:
• Overloaded: The tool
is operated in a manner
that causes it to draw an
abnormally high current. In this
situation, release the Trigger
Switch on the tool and stop the
application that caused the tool
to become overloaded. Then
pull the Trigger Switch again
to restart.
• Overheated: Under the
condition above, if the tool
does not start, the Tool and
Battery are overheated. In
this situation, let the Tool and
Battery cool before pulling the
Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity
is too low and the tool will
not operate. In this situation,
remove and recharge the
Battery.
WARNING: To turn on
the light, press the On/
Off switch and make sure the
Forward/Reverse Rotation
Control is on right/left position.
ENG